![]() ![]() Connect all the cables that were removed. When closing the front cover, push the upper area of the cover firmly. Using both hands, carefully push up the front cover until it closes. Pull the front cover open lever and then carefully lower the front cover.īe sure to set the registration roller in the position shown by the arrow in the illustration below.Ĭlean the registration roller if prints are smeared after a paper jam is cleared.Ĭlean the registration roller by applying a soft damp cloth while turning it. Wipe the inside of the paper tray with a cloth. The registration roller and paper tray can become dirty with paper dust if you print to non-standard paper.Ĭlean the registration roller if white dots appear on prints.ĭo not touch the transfer roller (as shown below). If the optional Tray 2 is installed, clean its friction pad and paper feed roller in the same way as you did for Tray 1.If jam or multi-sheet feed still occurs after cleaning the friction pad, contact your sales or service representative.Insert the plug of the power cord into the wall socket securely. Reload the removed paper into the tray, and then push the tray carefully into the device until it clicks. Push the metal plate down until it clicks. After that, wipe it with a dry cloth to remove the moisture. Wipe the rubber part of the roller with a soft damp cloth. If there is paper in the tray, remove it. Pull out Tray 1 carefully with both hands. Unplug the power cord from the wall outlet. Do not use chemical cleaning fluids or organic solvents such as thinner or benzine.In this case, clean the friction pad and paper feed roller as follows: If the friction pad or paper feed roller is dirty, a multi-feed or misfeed might occur. Do not allow paper clips, staples, or other small objects to fall inside the device.Accumulated dust and grime pose a fire hazard. Clean away any dust and grime from the plug and outlet before reconnecting. You must disconnect the plug from the wall outlet at least once a year.If there is dust or grime inside the device, wipe with a clean, dry cloth.To avoid deformation, discoloration, or cracking, do not use volatile chemicals, such as benzine and thinner, or spray insecticide on the device.If you still cannot remove the stain or grime, use a neutral detergent, wipe over the area with a thoroughly-wrung damp cloth, and then dry wipe the area and allow it to dry. If dry wiping is not sufficient, wipe with a soft, damp cloth that has been wrung out thoroughly. Differences in Functions between Different Models The differences in main functions between different models are as follows: SP C250DN SP C252DN Type 1 Type 2 Restrictions on available functions Not available Available User Restriction Not available Available Locked Print Not available Available Notification to replace a component Not available. The appearance may vary depending on the device.)Ĭlean the device periodically to maintain high print quality.ĭry wipe the exterior with a soft cloth. (Note: Illustrations are provided for reference purpose only. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |